#COMMON DOG TRAINING HAND SIGNALS HOW TO#
#COMMON DOG TRAINING HAND SIGNALS DRIVERS#

Most industry regulations are met by the seven OSHA forklift hand signals as listed above.

#COMMON DOG TRAINING HAND SIGNALS HOW TO#

Had Hector known and understood how to use hand signals to communicate with the operator this unfortunate accident could have been prevented. Emergency services were called but when they arrived the operator was already dead. The operator tried to jump out as it fell over and was crushed by the forklift. The load kept tilting and caused the forklift to tilt over. The operator could not hear Hector because the site they were working at had many other machines and operations running that were very loud. Hector began yelling at the operator to tilt the tines upward to prevent the load from falling. While Hector was spotting the operator, he noticed that the load looked unbalanced and slowly began sliding off the tines. Hector was working as a spotter for a fellow employee who was operating a forklift. A spotter using these hand signals can make sure the operator can complete their task promptly, safely, and efficiently.

#COMMON DOG TRAINING HAND SIGNALS DRIVERS#

Why Should I Use Proper Hand Signals?Īs stated previously, forklift hand signals are helpful for instructing forklift drivers while they transfer and move cargo on a forklift. For this one both arms must be used creating one horizontal line outwards from your body. This signal immediately stops all operations until the emergency is dealt with.

An emergency response can be called when there is imminent danger or after an accident occurs. This is the only signal that anyone in the workplace can give. To perform this signal you must keep your hands flat and cross your thumbs together in front of your body. When used, this signal tells the operator to pause everything and stop moving until the pathway is cleared. This signal is used when an unexpected safety hazard appears but has not yet caused any harm. This signal can be made by putting one arm straight out from your body horizontally and making a thumbs-down motion. Spotters use this signal when operators need to angle the end of their mast lower to the floor. To use this signal you will need to put one arm straight out from your body horizontally and make a thumbs-up motion. The mast back motion signals that the operator needs to angle the end of the mast higher off the ground. To communicate this signal, all you have to do is point straight out from your body horizontally with either your left or right hand depending on the direction the operator needs to adjust those tines.

This signal tells the operator to adjust their tines either left or right. This signal is portrayed by pointing your index finger up and drawing a circle in the air continuously. The raise the tines signal is utilized to let the operator know when they need to lift the load. This signal is executed by having one arm straight out from your body and pushing down with an open hand. When it’s time to lower a load, the lower tines signal is employed. These seven hand signals are as follows: #1 – Lower the Tines Operators will only listen to directions from spotters, although anyone on the job site has the authority to signal an emergency stop. The forklift’s tines, mast, and brakes are the target for these hand signals, which all relate to the forklift’s essential parts. The seven standardized OSHA forklift hand signals are used by most companies. Hand signals allow the operators to communicate with spotters while moving heavy loads.

Order 10 for $10.00 or save by ordering 25 for $20.00.įorklift Hand Signals That You Need To Know Forklift Hand Signals These hand signal cards for operators are easy to use with high-quality images of important hand signals for mobile cranes, telehandlers, forklifts, and more! They fit nicely in your wallet or pocket and provide the crucial information you need while on a job site.

Common dog training hand signals